Units of Measure

You can use Agave Sync to ensure that Units of Measure are properly translated between Autodesk Build and Foundation.

Visual Mapping

Common FAQs

Adding Units of Measure to Autodesk Build

If you receive an error like the following: "The Unit of Measure associated with this model has not been synced", it's possible the Unit of Measure may not exist in Autodesk Build. To fix this error:

1. In an Autodesk Build Project, go to Cost Management-->Settings:

2. In the General tab, select the Unit of Measure section. Then press Add unit:

tip

Make sure to add new Units of Measure to your Project Template so it is available for all new Projects.

Adding Units of Measure to Foundation

If you receive an error like the following: "The Unit of Measure associated with this model has not been synced", it's possible the Unit of Measure may not exist in Foundation. To fix this error:

1. From Foundation's homepage, go to Job Costing --> Maintenance:

2. Select Units of Measure:

3. Add the Unit of Measure, and press OK: